A clean revolver is a reliable revolver. This guide walks through a basic cleaning that takes about fifteen minutes and keeps your wheelgun running for years.
Safety first. Before anything else, confirm the firearm is unloaded. Open the cylinder, visually and physically check every chamber, and set all ammunition in another room.
What You’ll Need
- A cleaning rod and bore brush sized to your caliber
- Cleaning patches
- Solvent and gun oil
- A clean microfiber cloth
The Steps
- Bore. Run a solvent-soaked patch through each chamber and the barrel, then follow with the bore brush. Finish with dry patches until they come out clean.
- Cylinder face. Powder builds up here fast. A nylon brush and a little solvent clear it without scratching the finish.
- Action. A drop of oil on the moving parts keeps the trigger smooth. Do not overdo it; excess oil attracts grit.
- Wipe down. Run the microfiber cloth over every exterior surface to remove fingerprints and leftover solvent.
Final Check
Cycle the action a few times, confirm everything moves freely, and store the firearm safely. That is it; you are done.
